Unbenannt

CT4/8-Wheel
4/8 Channel Wheel Telemetry System
Including signal conditioning for STG, Th K, ICP, POT or high-level inputs

· STG offset via potentiometer or optional Auto Zero calibration	· Output analog (+/- 5V) and digital for PC interface at the receiver side
· 12 bit ADC resolution, simultaneous sampling of all channels	· Universal mounting adapter for fast and exactly montage on the wheel
· Signal bandwidth: 4 x 0-190 Hz, 8 x 95 Hz with 40kbit Tx 4 x 0-1500 Hz, 8 x 750 Hz with 320kbit Tx 4 x 0-3000 Hz, 8 x 1500 Hz with 640kbit Tx	· 4 different carrier frequencies (only with 40kbit Tx) enable measurements at 4 Wheels for one car
· Water protected housing (IP65)	· Accumulator powered (up to 6-12h)

CT4/8-Wheel is an telemetry system designed for easy mounting onto rotating Wheels to provide non-contact transmission of measured parameters such as pressure, force, temperature, acceleration and voltage.

Sensors inputs are connected via screw on, waterproof connectors. Measured values are prepared in analog format, digitized and transmitted via radio frequencies. Four different carrier frequencies are provided, this allows up to four systems (e.g. for four wheels) to operate in parallel. The complete transmitter assembly is waterproofed to IP65 specifications.

The following sensors can be connected to the system: (STG) Strain gages sensors in full-, half- and quarter-bridge configuration (350 ohm or greater), Type K Thermocouples to 1000°C, ICP and capacitive sensors. Voltage inputs of +/-5V and +/-10V are available.

The measured values are processed and output as +/-5V analog signals at the BNC sockets (optional digital output for special PCM interface into a PC) on the stationary receiver located in a vehicle or helicopter cabin.

Resolution of 12 bits is standard; this enables an amplitude dynamic of 72 dB. The analog signal bandwidth is 0-95 Hz (-6dB) when configured as an eight channel unit. The measurement accuracy is +/-0.5 % (without sensor). The CT4/8-Wheel is suited for operation at ambient temperatures of -20 to +70°C. The transmission distance between transmitter and receiving antenna is of the order of 10m (30 feet) - depend of application!

Picture shows a CT4-Wheel Telemetry system with standard accessories